EdilKamin FORTE PLUS Instalación Uso Y Mantenimiento página 18

INSTALLATION INSTRUCTIONS
External air inlet (figures E-F-G)
It is absolutely necessary, without
exception, to build a connection to the
outside with a cross-section of 300 cm²
for the proper functioning of the fire-
place.
This connection must link the adju-
stment mechanism outlet located on the
side of the mechanism itself with the
outside.
This can be achieved with a flexible alu-
minium pipe and properly sealing the
points where air leakage could occur.
The Ø20 aluminium pipe can be posi-
tioned independently either to the
right or to the left of the adjustment
mechanism.
It is advisable to place a protection gril-
le on the outer part of the air inlet chan-
nel, nevertheless ensuring that this does
not reduce the cross-section.
The inflow of outside air must be at floor
level (it can not come from above).
.
When positioning the outdoor air
damper control cable (4c), make sure
that it does not come into contact with
the hot parts of the fireplace, as this
will damage the plastic sheath.
fig. E
fig. F
fig. G
Transporting the fireplace
In order to facilitate transportation, the
fireplace can be made lighter by remo-
ving the following:
- counter weights, cast iron bottom, cast
iron sides, cast iron hearth, the ash pan, the
ash grill made of cast iron, the outer shell.
It is also possible to remove the door by
doing the following:
Step 1 (fig. H)
- lower the door until it is completely
closed, tighten the Allen screws (X)
until they are fully screwed in.
X
fig. H
Step 2 (fig. I)
- open the hinged door, loosen the grub
screw (Y) and fully unscrew the hex
head screw (Z).
- carefully pull the bottom of the door
towards you in order to remove it.
Z
Y
fig. I
18
Cleaning the glass (fig. L)
- To clean the glass you can open the
hinged door to the firebox by
unlocking the latch plate using the
special tool (protective tool included)
on the right side of the door (
turn 90°).
- The door can now be opened as a
hinged door.
- When you finish cleaning, re-fasten
the latch plate.
fig. L