Nostalgia Products HomeCraft CBD5BS Instrucciones página 11

Assembly of 5L Standard Non-Pressurized Kegs
1. Follow any required instructions marked on the keg to eliminate excess gas, and to
ensure the keg has rested long enough to avoid foam coming out of the Tap Faucet.
2. Place the Keg Adapter (square) into the top opening of the Keg Lifter,
then screw the Dip Tube into the bottom of the Beer Line Connector.
When done correctly, this will secure all three pieces together.
3. Pierce the seal on the top of the keg and place the Keg Bung into the opening.
4. Insert the Dip Tube into the Keg Bung and fully into the keg.
5. Secure the ends of the Keg Lifter onto the lip of the keg.
Keg Adapter (square)
Keg Lifter
Dip Tube
Keg Bung
Keg
9