cecotec HidroBoost 1400 Manual De Instrucciones página 23

surface, thereby preventing the desired cleaning action.
The optimum angle for spraying water against a cleaning
surface if 45 degrees.
Spraying water against a surface at this angle provides for the
most beneficial impact force combined with efficient removal
of debris from the surface.
DISTANCE FROM CLEANLING SURFACE
The impact force of the water is increased as the pulverizing nozzle is moved closer to the
surface.
HOW TO AVOID DAMAGING SURFACES
Damage to cleaning surfaces occurs because the impact force of the water exceeds the
hardness of the surface. The impact force can be varied by controlling the three previously
noted items. Never use a narrow high impact stream on a surface that is susceptible to damage.
Avoid spraying windows with a narrow high impact stream as this may cause breakage.
The surest way to avoid damaging surfaces is to follow these steps:
• Before triggering the gun, adjust the pulverizing nozzle to a wide stream.
• First, follow the distance and angle instructions above.
• Vary the spray angle, stream type and the distance to the cleaning surface until optimum
cleaning efficiency is achieved without damaging the surface.
CLEANING PROCESS
1. Surface preparation
Clean the area of furniture and make sure all windows and doors are closed tight. Also, make
sure that all plants and trees near the cleaning area are protected by a drop cloth.
2. Initial high-pressure rinse
Spray the cleaning surface with water to clear off any dirt or grime that may have collected
on the surface. Before triggering the gun, adjust the pulverizing nozzle to a wide stream and
slowly adjust it to the desired stream. This will avoid applying too much concentrated spray to
the surface which could cause damage.
3. Final rinse
Start the final rinse at the bottom and work upward. Make sure the surface is thoroughly
rinsed and that al dirt is removed.
ENGLISH
HIDROBOOST 1400 23