Installing And Removing The Battery Pack - DeWalt DCF805 Manual De Instrucciones

Installing and Removing the Battery Pack

(Fig. C)
NoTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
6
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 5 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
5
6
Proper Hand Position (Fig. D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main
handle .
8
Fig. D
Variable Speed Trigger Switch (Fig. A)
To turn the tool on, squeeze the trigger switch
the tool off, release the trigger switch. Your tool is equipped
with a brake. The chuck will stop when the trigger switch
is fully released. The variable speed switch enables you to
into the tool handle, align the
8
1 . To turn
select the best speed for a particular application. The more
you squeeze the trigger, the faster the tool will operate. For
maximum tool life, use variable speed only for starting holes
or fasteners.
NOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should be
avoided.
Forward/Reverse Control Button (Fig. A)
A forward/reverse control button
direction of the tool and also serves as a lock off button.
To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool. To select reverse, depress the forward/
reverse control button on the left side of the tool. The
center position of the control button locks the tool in the off
position. When changing the position of the control button,
be sure the trigger is released.
NoTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
Quick-Release Chuck (Fig. A, E, F)
NoTE: The chuck accepts 1/4" (6.35 mm) hex accessories
and 1" (25.4 mm) bit tips only.
Place the forward/reverse button
(center) position or remove battery pack before changing
accessories.
To install an accessory, fully insert the accessory. The
accessory is locked into place (Fig. E).
To remove an accessory, pull the chuck collar
from the front of the tool. Remove the accessory and release
the collar (Fig. F).
Fig. E
4
Fig. F
3
4
ENglIsh
determines the
2
in the locked off
2
3 away
3
29