Installing And Removing The Battery Pack - DeWalt DCS354 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
2. Secure the block to the main body with the supplied
screw
17
and washer
14
hex wrench 
18
.
Fig. F
5
16
Depth Guide (Fig. G)
This feature allows you to precisely cut material at a
specified depth.
1. Insert the guide arm
7
into the front slot on the guide
block
6
.
2. Adjust the length of the guide by pulling out or pushing
inward to achieve the desired cut depth.
3. Secure the guide in place by turning the depth/cut
adjustment knob
clockwise. To release the guide,
19
turn the depth/cut adjustment knob counterclockwise.
Fig. G
7
Cut Guide (Fig. H)
This feature allows you to more accurately track a marked
cut line.
1. Insert the guide arm
7
into the slots on the left and
right sides of the cut guide block
2. Adjust the length of the guide by pulling out or pushing
inward to achieve the desired length.
3. Secure the guide in place by turning the depth/cut
adjustment knob
19
clockwise. To release the guide,
turn the depth/cut adjustment knob counterclockwise.
nOTE: The guide arm can also be placed in the guard
assembly vertically in order to set the height of a cut.
10
.Tighten with the supplied
6
14
17
18
6
19
.
6
Fig. H
7
6
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury..

Installing and Removing the Battery Pack

(Fig. I)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
 8 
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
 9 
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
Fig. I
9
Proper Hand Position (Fig. J)

WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 
11
.
19
into the tool handle, align the
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dcs356

Tabla de contenido