Operation
Turning the TV On and Off
Press the POWER
button on the remote control.
You can also use the POWER
Plug & Play Feature
When the TV is initially powered on, basic settings proceed automatically and subsequently:
1. Press the POWER button on the remote control.
The message "Menu language, Shop Mode, Channels and Time will be set." is
displayed.
Press the ENTER button,
is automatically displayed.
2. Press the ▲ or ▼ button to select language, then press the ENTER button.
The message "Select Home Mode when installing this TV at home." is displayed.
3. Press the ◄ or ► button to select "Shop" or "Home", then
press the ENTER button.
The message "Select the antennas to memorize." is displayed.
We recommend setting the TV to Home mode for the best picture in your
home environment.
Shop mode is only intended for use in retail environments.
If the unit is accidentally set to Shop mode and you want to return to Dynamic
(Home) mode, press any Volume button and then hold down the MENU button
for five seconds on the side panel of the TV.
4. Press the ▲ or ▼ button to memorize the channels of the selected connection.
Press the ENTER button to select "Start".
If the antenna is connected to ANT 1(AIR), select "Air" and if it is connected to
ANT 2 (CABLE), select "Cable".
If both ANT 1 (AIR) and ANT 2 (CABLE) are connected, select the "Air + Cable".
In Cable mode, you can select the correct signal source among STD, HRC,
and IRC by pressing the ▲ or ▼ button, then press the ENTER button.
Contact your local cable company to identify the type of cable system that
exists in your particular area.
5. The TV will begin memorizing all of the available channels.
After all the available channels are stored, the Auto program menu reappears.
Press the ENTER button when channel memorization is complete.
The message "Select the clock mode." is displayed.
To stop the search before it has finished, press the ENTER button with stop
selected.
6. Press the ENTER button.
P ress the ▲ or ▼ button to select "Auto", then Press the ENTER button.
The message "Set to daylight savings time." is displayed.
If you select "Manual", "Set current date and time." is displayed. (See page 48)
button on the TV.
then "Select the language of the OSD"
English - 12
menu
Select the language of the OSD.
Menu Language :
Select Home Mode when installing this TV at home.
Select the antennas to memorize.
Air
Cable
Air+Cable
Auto Program in progress.
Auto Program is complete.
16 Channels were memorized.
Air : 16, Cable : 0.
Clock Set
Select the clock mode.
Clock Mode
Menu language, Shop Mode,
Channels and Time will be set.
Start
Plug & Play
English
Español
Français
Move
Enter
Skip
Plug & Play
Shop
Home
Move
Enter
Skip
Plug & Play
Start
Start
Start
Move
Enter
Skip
Plug & Play
Plug & Play
Air Channel 50
5%
Stop
Enter
Skip
Plug & Play
Plug & Play
OK
Enter
Skip
Plug & Play
:
Manual
Auto
Move
Enter
Skip