Craftsman 247.888530 Manual Del Propietário página 10

• Place the cable barrel fitting into the hole in the
trigger. You can find the triggers and associated
hardware in group H of the hardware pack. See
Figure 12.
Trigger
Assembly
Inner Cable
Cable
Barrel
Fitting
Figure 12
• Pull on the cable and rotate it around the bottom
of the trigger, with the inner cable in the slot, until
the cable end can be pushed into the trigger
housing and snapped tight. See Figure 12.
NOTE: When the cable is installed correctly, you
should not be able to pull the cable out of the trigger
housing.
• Place the right turn trigger in position
underneath the right handle. Secure with screw
and weld nut from group H of the hardware
pack. See Figure 13. You will need a phillips
screwdriver for tightening the screw. Repeat on
left side.
Weld Nut
Slot
Figure 13
• Secure the right turn trigger cable to the right
lower handle using cable tie provided in the
hardware pack. Make sure not to wrap the drive
cable. See Figure 14.
Trigger
Housing
Slot
Cable snaps in at
this end
Secure with screw
Turn
Trigger
Trigger
Cable
Cable Tie
• Secure the left turn trigger cable to the lower
handle using the other cable tie. Make sure to
route the cable tie below the auger drive cable
so that when the trigger cable is secured by the
cable tie, the auger drive cable is left outside the
cable tie. Trim excess ends from each cable tie.
NOTE: The right side cable tie must be used to keep
cable from coming in contact with the moving shift
arm from the transmission.
Lamp Wiring
• Wrap the wire from the lamp down the right
handle as shown in Figure 15.
• Plug wire into the alternator lead wire under the
fuel tank. See Figure 15.
Lamp
Wire
IMPORTANT: Assemble your snow thrower, then
check the adjustments as instructed and make any
final adjustments necessary before operating the unit.
Failure to follow these instructions may cause
damage to the snow thrower.
10
Trigger Cable
Figure 14
Trigger Cable
Handle
Alternator
Lead
Figure 15