Assembly & Installation - Urrea HL1055 Manual De Usuario

- Intake water pressure: below 10 bar.
- Operating ambient temperature over 0°C in
accordance with standard EN 60335-2-79/A1
only for domestic model.
IMPROPER USE
Use by unskilled persons or those who have
not read and understood the instructions in
the manual is forbidden. The introduction of
inflammable, explosive and toxic liquids into
the appliance is prohibited.
Use of the appliance in a potentially inflam-
mable or explosive atmosphere is forbidden.
The use of non-original spare parts and any
other spare parts not specifically intended for
the model in question is prohibited.
All modifications to the appliance are prohib-
ited. Any modifications made to the appliance
shall render the Declaration of Conformity null
and void and relieve the manufacturer of all
liability under civil and criminal law.
ASSEMBLY & INSTALLATION
ASSEMBLY
WARNING: All installation and assembly op-
erations must be performed with the machine
disconnected from the mains power supply.
1. Insert the han-
dle to the top of
the washer and
install the screws
that were includ-
ed in the package.
Then insert the
second element as
shown in the illus-
tration.
2. Install the lance
with gun.
E N G L I S H •
3. Connect the
gun and hose.
4. Make the con-
nection of the
hose with the
product tank as
shown in the illus-
trations.
Water inlet with
filter.
WATER SUPPLY CONECTION
IMPORTANT: Only clean or filtered water
should be used for intake. The delivery of the
water intake tap should be equal to that of
pump capacity.
ADJUSTMENTS
ADJUSTING THE SPRAY NOZZLE
Water flow is adjusted by regulating the noz-
zle.
Fan
Jet
ADJUSTING THE DETERGENT
Detergent flow is adjusted using the regulator.
ADJUSTING THE DETERGENT PRESSURE
Set the adjustable nozzle on "−" to deliver de-
tergent at the correct pressure.
U se r's m a nua l
Water outlet
(to the tool).
11