Operation Instructions - Urrea HL1055 Manual De Usuario

ADJUSTING THE PRESSURE
The regulator is used to adjust the working
pressure. The pressure is shown on the pressure
gauge (where fitted).
OPERATION
Turn the tool ON. Set the power switch in the
"| " position.
a) Start the engine.
b) Prepare the engine for starting.
The power switch has a pilot light, is lit when
the switch is activated on the ON position.
VERY IMPORTANT:
THE PRESSURE WASHER SHOULD BE KEPT IN
A HORIZONTAL POSITION DURING THE OPERA-
TION, BE SURE TO KEEP IN POSITION SHOWN
IN FIGURE.
WARNING: Before starting up the appliance
check that the water supply hose is connected
properly; use of the appliance without water
will damage it; do not cover the ventilation
grilles when the appliance is in use.
On three-phase models for professional use,
at first use start the appliance for a very short
time to check that the motor is running in the
correct direction.
IMPORTANT: If the motor fan is turning
anti-clockwise, exchange two of the three
phase wires (L1,L2,L3) in the electrical plug.
12
STARTING THE PRESSURE WASHER
1. Turn on the water supply tap fully.
2. Release the
safety catch.
3. Depress the gun
trigger for a few
seconds and start
up the appliance
using the starter
device.
TSS models: TSS models with automatic deliv-
ery has flow cut-off system;
- when the gun trigger is released the dynamic
pressure automatically cuts out the motor;
- when the gun trigger is depressed the auto-
matic drop in pressure starts the motor and the
pressure is restored after a very slight delay;
- if the TSS is to function correctly all gun re-
leasing and depressing operations must be per-
formed at intervals of less than 4-5 sec.
NOTE: To prevent damage to the appliance,
when running do not stop the water jet for
more than 10 minutes at a time.
STOPPING THE APPLIANCE
1. Set the starter device switch on "OFF".
2. Depress the gun trigger and discharge the
residual pressure inside the hoses.
3. Engage the gun safety catch.
RESTARTING
1. Release the safety catch.
2. Depress the gun trigger and discharge the
residual air inside the hoses.
3. Set the starter device on "ON".
STORAGE
1. Switch the appliance "OFF".
2. Remove the plug from the socket.
3. Turn off the water supply tap.
4. Discharge the residual pressure from the gun
until all the water has come out of the nozzle.
5. Drain the detergent tank.
6. Engage the gun safety catch.
REFILLING AND USING DETERGENT
When using detergent, the adjustable nozzle
must be set on "−". Fill the tank with highly
degradable detergent.
RECOMMENDED CLEANING PROCEDURE
Dissolve dirt by applying the detergent mixed
with water to the surface while still dry.
When dealing with vertical surfaces work from
the bottom upwards.
catch