Technical Data; Before Starting - EINHELL RG-CG 7,2 Li Manual De Instrucciones

Anleitung_RG_CG_7_2_Li_SPK7:_

4. Technical data

Speed n :
0
Cutting width of the grass cutter:
Cutting width of the shrub shears
Cutting thickness of the shrub shears
Running time max.:
Battery pack: Li-Ion / 7.2 V d. c. / 1.4 Ah
Charging time:
Protection class:
L sound pressure level:
pA
L sound power level:
WA
Vibration a grass shears:
hV
Vibration a shrub shears:
hV
Weight:
Battery charger
Mains voltage
Output
Rated voltage
Rated current:
Sound and vibration were measured in accordance
with EN ISO 3744.

5. Before starting

5.1 Charging the battery pack (Figure 1, 5)
Connect the charger to the charging station
(Figure 5).
Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger in a socket-
outlet. The green LED (Figure 5 / Item 1) comes
on to indicate that charging voltage is available.
The battery pack is being charged. An empty
battery pack requires a maximum charging period
of 3 to 5 hours. The temperature of the battery
pack may rise slightly during the charging
operation. This is normal.
As soon as battery pack is fully charged, the red
LED (Fig. 5/Item 1) extinguishes
20.11.2008 16:53 Uhr Seite 11
If the rechargeable battery fails to charge, check
whether there is voltage at the socket outlet.
1000 rpm
Timely recharging of the battery pack will help it
serve you well for a long time. Recharging is always
85 mm
necessary when you notice a drop in the toolʼs
120 mm
performance.
8 mm
Never allow the battery pack to become fully
45 min
discharged. This will cause it to develop a defect.
3-5 h
5.2. Fitting the long handle
III
Using the telescopic long handle (Fig. 1/Item 5) you
can push the cordless shears on wheels over the
59.5 dB
lawn.
82 dB
≤ 2.5 m/s
2
Undo the clamp coupling (Fig. 1/Item 6), adjust the
telescopic handle to the required length and then re-
≤ 2.5 m/s 2
tighten the clamp coupling again. Now push the
1.5 kg
equipment in the direction indicated by the arrow into
the mount (Fig. 3b/Item 8) as shown in Figure 3b.
Ensure that the mount locks into the recesses
correctly. The equipment is provided with one recess
230 V ~ 50 Hz
at the top for standard cutting and two recesses on
the left and right for cutting edges.
Important!
8.2 V DC
The switching arrangements installed on the tool
500 mA by the manufacturer must not be removed or
bypassed, e.g. by fitting a switching button to
the handle, as this may result in risk of injury
and the tool will no longer switch off
automatically.
6. Operation
The area to be cut must first be cleared of stones
and other solid objects. The safety lock-off (Fig.
1/Item 3) prevents the tool being started
unintentionally. Activate the safety lock-off (Figure 1 /
Item 3) by pushing it forward and pressing the
ON/OFF switch (Figure 1 Item 4) at the same time.
To switch off the tool, let go of the ON/OFF switch
(Figure 1 / Item 4).
GB
11