Maintenance Schedule; Change Oil - Briggs & Stratton 1696506-01 Manual Del Operador

Maintenance

Maintenance Schedule

First 5 Hours

Change oil

Before Each Use
Check engine oil level
Perform the snowthrower safety test
Check scraper bar and rubber auger for wear
After Each Use
Remove accumulated snow and slush to prevent freezing of the
controls, wheels, discharge chute, and auger
Every 25 Hours or Annually
Check snowthrower for loose hardware
Check auger control cable adjustment
Every 50 Hours or Annually
Change engine oil
Check condition of muffler and muffler guard
Annually
Replace sparkplug
Check valve clearance *
* Not required unless problems are noted with engine
performance. See an authorized service dealer for this item.
Emissions Control Service
Maintenance, replacement, or repair of the emissions control
devices and systems may be performed by any non-road engine
repair establishment or individual. However, to obtain "no charge"
emissions control service, the work must be performed by a
factory authorized dealer.
Change Oil
Used oil is a hazardous waste product and must be disposed of
properly. Do not discard with household waste. Check with your
local authorities, service center, or dealer for safe disposal or
recycling facilities.
Remove Oil
1. With engine off but still warm, remove the key and then dis-
connect the sparkplug wire (A, Figure 8) and secure it away
from the sparkplug.
NOTE: To access the sparkplug wire, you must remove the
snow hood from the engine. See Access the Sparkplug.
2. Remove the oil drain plug (B, Figure 9) and tilt the
snowthrower slightly to drain the oil into an appropriate con-
tainer.
3. After the oil has drained, install and tighten the oil drain plug.
8
9
B
Add Oil
1. Ensure the snowthrower is level.
2. Clean the oil dipstick area of any debris.
3. See Specifications for the oil capacity.
4. Remove the oil dipstick (A, Figure 3) and wipe it with a clean
cloth.
5. Add oil slowly into the engine oil fill (B).
6. Wait one minute and then insert the oil dipstick and turn it clock-
wise to tighten.
7. Remove the oil dipstick and check the oil level.
8. If necessary, add oil until the level reaches the full mark (C) on
the oil dipstick. Do not overfill.
9. Insert and tighten the oil dipstick securely.
A
15
en
English