Fagor 3FE-8612 Manual De Instrucciones página 99

Start/Pause button
9
Press Start/Pause to start or pause a programme. During the washing cycle the
corresponding programme phase symbol is flashing. In Pause mode, the symbols
do not flash and are lit up continuously. The Pause mode can be used to soak the
laundry.
Under the Start/Pause button there is the
to add laundry during the programme, such as pants, shirts or socks). Washing
machine clearly indicates when you can add more laundry.
The Add+ option is the perfect solution for all those who are forgetful! You can open
the door during the wash cycle, so that you add or remove laundry even a long time
after the programme has started. The LED indicator on the Control Panel indicates
pausing a programme is possible. When can stop the programme and add the
laundry, the display flashes the icon
and the water level below the door seal, you can stop the programme by pressing
the Start/Pause and then instantly unlock door to add laundry. The available
options will be communicated through quick flashing of the relevant indicator (until
programme progresses to 70-80%). Although this option is available for almost the
entire duration of the programme it is recommended that you use it in the first 30
minutes to maximize the results.
Acoustic Signal On/Off
4+5
The Acoustic Signal On/Off is activated by simultaneously pressing and holding:
Temperature selector and Spin Speed buttons for about 3 seconds.
Child Lock
7+8
This function locks function buttons to prevent settings being changed or operation
interrupted by children. Pres and hold Rapid Wash and Optiones buttons for 3
seconds to activate the Child Lock during a washing cycle. To release Child Lock
during the cycle, hold the same buttons down once more for around 3 seconds.
When If the Child Lock function is activated, the display will show the
turn off or unplug the washing machine or the washing cycle ends, the Child Lock function
will not deactivate.
Select a favourite programme.
To set the Favourite programme turn the knob on any programme and set
temperature, spin speed and additional functions. Then, press and hold down
the Temperature button for about 3 seconds to confirm the Favourite programme
setting. When saved, the setting will ne now always available under Favourites. You
can change the Favourite programme as many times as you want. The default is
the Cotton programme.
Add+ option button (allowing you
Add+. If the temperature is below 60°C
symbol. When you
99