Troubleshooting Naída Ci Q70 Leds - Advanced Bionics Naída CI Q70 Guía De Usuario

If these measures do not resolve the problem, contact your hearing care professional or
Advanced Bionics immediately for further assistance.
If sounds are muffled or distorted:
Confirm that no clothing or material is obstructing the microphone opening.
1
Repeat the troubleshooting steps for when static is heard, listed above.
2
If the Naída CI battery contacts appear to have rust forming on them:
Clean the contacts with a hearing aid brush or dry cotton swab.
1
If the Naída CI Q70 sound processor does not power up:
Remove and replace the battery cartridge.
1
Verify that a charged PowerCel or two fully charged Zn-Air batteries are in place.
2
Verify that the PowerCel is seated properly or the Zn-Air batteries are inserted correctly.
3
If the problem continues, contact a hearing care professional or Advanced Bionics for
4
further assistance.
If no sound is heard with an FM/Roger or auxiliary audio device attached to the ComPilot:
Verify that the FM/Roger receiver and/or auxiliary audio device is attached firmly to the
1
ComPilot.
Verify that the ComPilot is powered on.
2
Verify that the FM transmitter, Roger microphone, and/or external audio device are
3
powered.
Verify that you are using a program which allows for auxiliary, or Aux, input to the Naída CI
4
and that the Naída CI is wireless enabled.
Verify that the FM/Roger receiver has been programmed for use with the Naída CI.
5
Verify that the ComPilot neckloop is worn correctly around the neck, with the ComPilot
6
lying approximately mid chest.
If these measures do not resolve the problem, contact a hearing care professional or Advanced
Bionics for further assistance.
Troubleshooting Naída CI LEDs
The Naída CI LEDs are a programmable feature providing diagnostic information regarding
battery life, microphone function, pairing capabilities, or processor status. Refer to the
Naída CI Q70 Sound Processor User Guide
57