Backlight Operation; Charge The Battery; Menu Set - Baxtran DSC Manual De Usuario

Model DSC

backligHt oPeration

1. Two backlight modes are available here: "No backlight" mode and "auto-backlight" mode. The "No backlight" will never show the
backlight under any condition. The "auto-backlight" mode will light up the backlight when any key is pressed or when the weight on
the scale is more than 5d. Five seconds later, the light will extinguish after the weight comes to "0".
2. Under the mode of weight measuring, you will enter into the other backlight mode by keeping pressing
mode, the scale will automatically keep the backlight mode set previously when you turn the scale on again.

cHarge tHe battery

When the under voltage indicator is glittering, it shows the insufficient power and you need to recharge it in time. Connect to the power
supply to make the AC indicator light up. This stands for it's charging now. The average charging time is 12 hours.
electric quantity indication
1. When the under voltage glitters, it shows the insufficient power and need recharging in time.
2. If the display screen does not show or shows "Lo",this means The battery is in the self-protection state, and you should charge it in
time and then you can use it.

7. menu set

Press and hold before turning the scale on. The UNIT WEIgHT screen shows the information and the WEIgHT screen shows the
value. After all the set is over, it will automatically back out from the menu set and back to the weighing and counting mode. Press
for change the value and press
Specific set as follows:
Nº de serie
1
Zero tracing
2
3
Dynamatic examination
4
Warning internal and external
5
Average filter
6
Calibration mode
7
Sample speed
8
9
Auto-averaging
10
11
Zero memory
Counting scale
for go to next menu.
Pantalla Valor programa
Zero
Zrage
Zero range
D-rng
Pass
limit
Point
Spnt
Speed
Filt
filter
Aver
A-Salt
Alarm
OLoad
Programa de introducción
0d
0 stands fro no tracing.
1d
1 stands for tracing 1d
2d
The bigger tracing vlue, the quicker back to zero
3d
0d
1d
Quand plus grand est la valeur programmée, plus rapidement
2d retournera à zéro.
3d
0d
The bigger dynamic value is, the more stable is. But the re-
1d
solution is worse and it's suitable to be used in a worse en-
2d
viroment.
3d
0 0 stands for the warning internal limit presetting
1 1 stands for the warning external limit presetting
4
The bigger the filter point is, the more stable the scale is. But
8
the reaction speed is lower.
16
0 Multipoints calibration not allowed
1 Multipoints calibration mode allowed
0 Factory set
1 Fast sampling
0
1
2
3
0 Allow auto-averaging
1 Forbid auto-averaging
0 For counting
1 For weighing
0 Zero desviation correction
1 No zero desviation correction (zero memory ON)
User's Guide
key. After setting the
17