Display; Operation - Baxtran BCD Serie Manual De Usuario

5. DISPLAY

DESCRIPCIÓN DEL DISPLAY
The scales have three displays. Displays show WEIGHT, UNIT WEIGHT And QUANTITY
WEIGHT
WEIGHT DISPLAY
Is the display that indicates the weight located
in the scales..
The arrows on the symbols indicate the
following:
Low Battery Indicator ,
Weight Indicator "Net"
Stability indicator "Stable"
Zero Indicator, "Zero"
Unit in use Indicator "lb" or "kg"

6. OPERATION

• The functions of heavy basic his the same for both scales local y remote. without embargo the number of divisions of heavy can be lower in the balance
remote depending on of the capacity total of the cells of load used.
• Each balance (local or remote has the ability of count parts based in the unit of weight current. this is gets best using a sample in the balance local what
can have best sensitivity. then the balance can connect a area remote where large amounts can be counted.
• Each balance has a value tare different what can enter a thorough of keyboard o putting a weight about the platform y by pressing the button
value tare for each balance it retained while the user chooses between the balance remote o local.
• Any scale can be used to determine a unit of weight.
• When the scale is changed from local to remote, a new screen will appear to identify the change and the scales shall count based on the tare and the
weight unit currently in use in the balance selected. The display by the change is:chAngE LocAL y chAngE remotE
• The change of a balance local a remote must be possible in any moment by pressing the button
any moment what the weight about the balance change of a value negative o zero a value positive greater what 50d.
NOTE: For frequently used objects, the account can be simplified using numbers liked (product look up). up to 100 plu's they can be stored-two y remembe-
red. see section 6.4 in liked for details. place the object over of dish y between using the key "pluxx" (where xx it the number liked associated with this object).
the balance shows the weight total, the weight unit y the amount of object in the windows respective
24
WEIGHT UNIT
UNIT WEIGHT DISPLAY
• This screen shows the unit of weight of a
sample. this value is either entered by the user
manually or to through of the scale computer.
the restraint unit it the gram in all the scales with
kilograms selected as unit of weight or in pounds.
• When the scale has determined that there are
insufficient number of samples to accurately
determine the account will appear an arrow above
"Smpl".
• When the weight unit no it large enough to
determine a precise account, the arrow will
appear in "U.Wt".
• When a value has been entered in the memory
the arrow will be shown by over of "M+"
• In both cases the scale continues operating
and the indicators appear to instruct the user that
there is a potential problem.
OPERATION MANUAL BCD
AMOUNT
DISPLAY OF UNITS
• This screen shows the number of objects about the
balance or the value of the accumulated account. see
the section operation.
• An arrow by over of the symbols indicate the
following: active heavy check during the account, "Ck
Pcs" active heavy check during the heavy "Ck Wt".
Active heavy check, the result is above the ceiling,
"high" checking active heavy, the result is between
the lower and the upper limit, "ok"
active heavy check, the result is below the ceiling,
"low"
• Just under of the screen "count" there's a led for
indicate the state of the battery.
When the balance is plugged a the current the battery
internal is charge. If the led is green the battery has a
full charge. if it is red, the battery needs recharge y the
yellow indicates what the battery is loading.
o If the user selects the function can occur in
EN EN
. The