Electrical Connections - Hoshizaki HRE-70B Manual De Instrucciones

ENGLISH
* Avoid a site where dripping is not allowed.
Especially, a side-by-side or back-to-back
installation (possibly with other manufacturer's
unit) may cause condensation between the two
units, resulting in dripping onto the floor.
* Do not expose the unit to direct sunlight or higher
temperatures.
* Allow at least 00cm clearance at the front of
the unit for smooth door operation. Also allow at
least 30cm clearance from the ceiling to the top
of the unit for proper air circulation.
Min. 00cm
Fig. 3
2. SHELF AND RAIL
* The Shelf is adjustable in 2.5cm increments.
Adjust the Rail according to the height of stored
items.
* To attach the Rail, () push the Rail Hook
backwards to fit into the square hole in the rear
Shelf Post, and (2) push the Rail Hook down to
fit into the square hole in the front Shelf Post. To
detach the Rail, reverse the above procedure.
See Fig. 4.
CAUTION
Attach the Rails properly to make the Shelf
level.
Min. 30cm
(2)

3. ELECTRICAL CONNECTIONS

* This refrigerator/freezer must be plugged into
the separated power receptacle which is readily
accessible and has enough capacity. The
maximum allowable voltage variation should not
exceed ± 0 percent of the nameplate rating.
See the Nameplate.
* If the supply cord and the plug should need to be
replaced, it should only be done by a qualified
service engineer to avoid any danger.
2
() Hook
(2) Hook
()
Fig. 4