Install The Tower - Kohler K-1000-H2 Manual Del Usuario

27. Install the Tower

Locate the pin at the bottom left corner of the tower. Insert this pin into the bottom left corner hole
in the mounting frame bracket.
Align the hole at the top left corner of the tower with the slotted hole in the mounting frame and
thread a 3/8" bolt through the mounting frame and into the tower.
Securely wrench tighten the bolt.
Locate the electrical connector at the base of the tower.
Route this wire back to the pump controller.
Match the pins on the connector to the port on the controller and press firmly into place.
Securely hand tighten the tower union nut to the mounting frame union. Be sure the union O-ring is
in place.
Carefully pivot the tower closed. Align the holes at the top and bottom right corners of the tower
with the slotted holes in the mounting frame. Thread a 3/8" bolt through the mounting frame and
into the tower at the top and bottom. Tighten the bolts securely, but do not overtighten.
You will water test and inspect the tower and mounting frame later, so you may want to only install
and hand tighten one of the required bolts at this time. Both bolts will need to be securely tightened
later.
1032108-2-D
Tower
Pin
Mounting Frame Hole
Bottom Left Corner View
Top Left
Corner View
Tower
Union Nut Bolt
Tower
Mounting
Frame
Mounting
Slotted
Frame
Hole
Union
24 Kohler Co.