Install The Threshold - Kohler K-702010 Guia De Instalacion

Apply silicone sealant
under threshold edge

1. Install the Threshold

- Measure the length of the shower opening for the door. Mark this measurement on the threshold. The threshold
should run the entire length of the opening.
- Cut the threshold to the proper length with a miter saw or hacksaw. File the rough edges.
- Locate the threshold on the receptor ledge with the flat edge towards the outside (dry side) of the shower and
mark the location. Apply silicone sealant to the edge underneath the threshold and attach to the ledge.
Temporarily secure the threshold with masking tape.
NOTE: Do not locate tape on the hinge side, where the side lite bracket will be mounted.
Kohler Co.
Threshold
3
E
1011451-2-