INSTALLATION
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGMMT-01 harness into the
interface.
• Connect the AXGMMT-01 harness to the wiring harness in the vehicle.
• If an AXSWC (sold separately) will be used, do not connect it until the AXGMMT-01 is programmed
and fully functional.
Disregard these plugs and red wire,
they will not be used in this application.
Vehicle Connectors
Radio Connections
Chime Relay:
No connections required
Radio Connections
PROGRAMMING
AXGMMT-01 programming:
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio doesn't come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, then try again.
• Turn the key to the off position, then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
AXSWC programming:
1. With the key still cycled on, plug the AXSWC in. The LED in the AXSWC will flash rapidly.
2. Tap the Volume Up button on the steering wheel at a heartbeat pace until the LED stop
flashing rapidly.
3. After approximately 2 seconds there will be a series of 7 Green flashes, some short, and
some long. The long flashes represent the wires that are connected to the AXSWC.
4. The LED will pause for another 2 seconds, then flash Red up to (18) times depending on
which radio is connected to the AXSWC. Refer to the L.E.D. feedback section for information.
5. This is the end of the auto detection stage. If the AXSWC detected the vehicle and the radio
successfully, the L.E.D. will light up solid.
6. Test the steering wheel controls for proper operation. Refer to AXSWC documents online for
customizing the buttons, if so desired.
Continued on the next page
REV. 3/17/2021 INSTAXGMMT-01
5