Emerson ARLO WET CF344BQ00 El Manual Del Propietario página 7

3. Ceiling Fan Assembly
3.5
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4.5" Downrod (Figure 5).
Remove the Pin from the 4.5" Downrod, then remove the
Hanger Ball (Figure 5).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.12.
Note: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
3.6
Separate, untwist and unkink the Five 80" Motor Wires.
Route the Five 80" Motor Wires through the 4.5"
Downrod (Figure 6).
3.7
Loosen the two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 7).
Seat the Downrod in the Motor Coupler (Figure 7).
Rotate and align the Downrod Holes with the two Holes
in the Motor Coupler (Figure 7).
(Continued)
PIN
PHILLIPS HEAD SET SCREW
Figure 5
(LOOSENED)
Figure 6
DOWNROD
MOTOR
COUPLER
Figure 7
7
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
80" FAN MOTOR
WIRES (5)
4.5" DOWNROD
LOOSEN SET
SCREWS (2)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF344 & CF354