Installing The Grass Bag - Briggs & Stratton Brute 7800886 Manual Del Usuario

1.25 in
3,18 cm
Figure 10: Cutting height settings (approximate)
Installing the Discharge
Deflector
WARNING
!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all com-
ponents to cool.
1. Raise the mulching cover (A, Figure 11).
2. Install the deflector (B) to the deck under the
mulching cover, making sure that the locking tabs
on the deck (C) go through the slots in the deflec-
tor (B).
3. Lower the mulching cover against the deflector.
B
C
Figure 11: Installing the discharge deflector
en

Installing the Grass Bag

!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all com-
ponents to cool.
4.00 in
10,16 cm
Important: The mulching plug must be removed only
when bagging is desired, and must be replaced as
soon as bagging operations are completed.
1. Raise the rear discharge door (A, Figure 12).
2. Remove the mulching plug (B) from the rear dis-
charge chute.
!
Figure 12: Removing the mulching plug
A
3. Holding the grass bag handle (A, Figure 13),
install the grass bag onto the mower, making sure
that the grass bag hooks (B) are hooked onto the
rear door pivot rod (C).
Operation
WARNING
!
A
B
15