RIDGID R82237 Manual Del Operador página 6

OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page 8.
 To install, lock the switch trigger and insert the battery
pack.
 Make sure the latch on the side of the battery pack snaps
in place and that battery pack is secured in the product
before beginning operation.
 To remove, depress the latch.
LED LIGHTS
See Figure 4, page 8.
The LED lights around the coupler will come on when the switch
trigger is depressed. This provides additional lighting on the
surface of the workpiece for operation in lower-light areas.
INSTALLING/REMOVING BITS
See Figure 5, page 8.
 To install bits, lock the switch trigger by placing the
direction of rotation selector in the center position.
 Remove the battery pack.
 Push the bit into the coupler until it clicks into place.
 Pull on the bit to make sure it is secured in the coupler.
There may be some play in the installed bit; this is normal.
NOTE: Use only impact quality bits with a locking groove.
WARNING:
Make sure the bit is secured in the coupler before
using the impact driver. Failure to do so could
cause serious personal injury.
 To remove bits, lock the switch trigger by placing the
direction of rotation selector in the center position.
 Remove the battery pack.
 With the nose of the tool pointed away from you, pull the
coupler away from the driver.
 The bit will eject from the coupler.
USING THE IMPACT DRIVER
See Figures 6 - 7, page 8.
NOTICE:
The impact driver is not designed to be used as
a drill.
NOTE: Maintenance information begins on page 7 after French and
Spanish language sections. Figures (Illustrations) start on page 8.
This product has a 90-Day Satisfaction Guarantee Policy, as well
as a Three-year Limited Warranty. For Warranty and Policy details,
please go to www.RIDGID.com or call (toll free) 1-866-539-1710.
WARNING:
Do not drive a screw where there is likely to be
hidden wiring behind the surface. Contact with a
"live" wire will make exposed metal parts of the tool
"live" and possibly shock the operator. If you must
drive a screw where hidden wire may be present,
always hold tool by insulated gripping surfaces
(handle) when performing the operation to prevent
a shock to the operator.
 Check the direction of rotation selector for the correct
setting (forward or reverse).
 Hold the impact driver with one hand.
 Place the bit on the screw head, bolt head, or nut and
slowly depress the switch trigger. Start the bit slowly for
more control.
 As the screw, bolt, or nut is driven, impacting will begin.
ELECTRIC BRAKE
The electric brake will stop the bit rotation after the operator
releases the switch trigger.
ON-BOARD FUEL GAUGE
The on-board fuel gauge lights up to indicate the amount of
charge in the battery pack when the operator pulls the trigger.
LED INDICATOR
One LED begins flashing when
the battery pack needs to be
recharged.
6 - English
% CHARGED
0%-25%
26%-50%
51%-75%
76%-100%