Manufacturer's Warranty - Hilti TE 7-C Manual Del Usuario

Trouble or fault
The power tool doesn't start.
No hammering action.
The rotary hammer doesn't
achieve full power.
The drill bit does not rotate.
The drill bit cannot be re-
leased.
The drill bit makes no
progress.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.

10 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 10.10.2017 | Doc-Nr: PUB / 5071225 / 000 / 03
Possible cause
Interruption in the electric supply.
The power tool is too cold.
The function selector switch is set
to "Drilling without hammering"
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The control switch is not fully
pressed.
The function selector switch is not
engaged or is in the "Chiseling"
or "Chisel adjustment" position.
The chuck is not pulled back fully.
The power tool has been set to
reverse rotation.
Action to be taken
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Bring the tip of the drill bit
into contact with the working
surface, switch the rotary
hammer on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Set the function selector
. switch to the "Drilling with
hammering action" (hammer
drilling) position
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Press the control switch as far
as it will go.
▶ Set the function selector switch
to "Drilling without hammering"
or "Hammer drilling"
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Set the power tool to forward
rotation.
English
.
.
7