Manufacturer's Warranty; Further Information; Originele Handleiding; Informatie Over Documentatie - Hilti NURON TE 6-22 Manual De Instrucciones

Trouble or fault
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible click.
LEDs of the battery show
nothing
Product or battery gets very
hot.
The insert tool can't be re-
leased.
The tool makes no progress.
11 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
13

Further information

For more information on operation,
qr.hilti.com/manual?id=2264935&id=2264937
This link is also to be found at the end of the documentation, in the form of a QR code.

Originele handleiding

1

Informatie over documentatie

1.1 Over deze documentatie
• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
26 Nederlands
Possible cause
Battery condition is not optimal.
The retaining lugs on the battery
are dirty.
Battery defective
Electrical fault
The chuck is not pulled back fully.
Product has been set to reverse
rotation.
The function switch is set to
"Drilling without hammering"
technology, environment and recycling,
Action to be taken
▶ Call up the battery's state of
health. → page 20
▶ Clean the retaining lug and refit
the battery.
▶ Contact Hilti Service.
▶ Immediately switch off the
product. Remove the battery
and keep it under observation.
Allow it to cool down. Contact
Hilti service.
▶ Pull the chuck back as far as it
will go and remove the tool.
▶ Move the forward / reverse
switch to the "Forward" posi-
tion.
▶ Set the function switch to
. "Hammer drilling"
follow this link:
2264935
*2264935*
.