DeWalt DCD780 Manual De Instrucciones página 13

3. Insert the accessory about 3/4" (19 mm) into the chuck and
tighten securely by rotating the chuck sleeve clockwise with one
hand while holding the tool with the other. Your tool is equipped
with an automatic spindle lock mechanism. This allows you to
open and close the chuck with one hand.
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
To release the accessory, repeat steps 1 and 2 above.
FIG. 3 FIG. 4
F
Belt Hook and Bit Clip
(Optional Accessory) (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury, DO
NOT suspend tool overhead or suspend objects from the belt hook.
ONLY hang tool's belt hook from a work belt.
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
IMPORTANT: When attaching or replacing the belt hook or bit clip
(bit clip sold separately), use only the screw (H) that is provided. Be
sure to securely tighten the screw.
The belt hook (G) and bit clip (I) can be be attached to either side of
the tool using only the screw (H) provided, to accommodate left- or
right- handed users. If the hook or bit clip is not desired at all, it can
be removed from the tool.
To move belt hook or bit clip, remove the screw (H) that holds it in
FIG. 5
place then reassemble on the opposite side. Be sure to securely
tighten the screw.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 6)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (K)
into the tool handle, align the
battery pack with the rails inside
the tool's handle and slide it into
the handle until the battery pack
is firmly seated in the tool and
ensure
disengage.
To remove the battery pack
from the tool, press the release
button (J) and firmly pull the
battery pack out of the tool
handle. Insert it into the charger as described in the charger section
of this manual.
11
FIG. 6
J
that it does not
K