Temperature Measurements; Battery Replacement - Southwire 13070T Instrucciones De Operación

Operation cont.

Temperature Measurements

WARNINGS:
Do not touch the temperature probe to live circuits.
1. Set the rotary function switch
to the °F °C position.
2. Press the MODE button to
select readings in °F or °C.
3. Connect the Temperature Probe
to the Banana Plug Adapter.
Note the – and + markings on
the adapter. Connect the adapter
to the meter, making sure the –
side goes into the COM input
jack and the + side goes into
the °F °C input jack.
4. Touch the tip of the Temperature
Probe to the object being measured.
Keep the probe touching the object
until the reading stabilizes (about 30 sec).
5. Read the temperature on the LCD display.
n m VA F M k
0 10 20 30 40
AUTO HOLD MAX MIN REL LOZ
n m VA F M k
0 10 20 30
AUTO HOLD MAX MIN REL LOZ
15
Operation cont.

Battery Replacement

WARNINGS:
the meter before removing the battery/fuse cover.
1. Lift up the tilt stand.
2. Loosen the Phillips
40
screws on the battery/
fuse cover.
3. Remove the battery/fuse
cover.
4. Replace the batteries with
three AAA batteries.
5. Observe proper polarity
as shown inside battery
compartment.
6. Install the battery cover and
tighten the screws.
WARNING:
until the battery/fuse cover is securely fastened to the meter.
WARNING:
the battery compartment door firmly to maintain the waterproof and dust
proof integrity of the meter. Loose or overtightened screws, or an improperly
seated o-ring may compromise the meter's water and dust ingress protection.
To avoid electric shock, remove the test leads from
To avoid electric shock, do not operate the meter
When replacing the battery or fuses, be sure to secure
16