Accessories And Spare Parts; Accessories - WAGNER FINISH CONTROL 3500 Manual De Instrucciones

GB

ACCESSORIES AND SPARE PARTS

MALFUNCTION
Atomisation too coarse
Spray jet pulsates
The material runs down the
object being painted
Excessive paint mist (overspray)
Paint in the ventilating hose
15
ACCESSORIES AND SPARE PARTS
15.1

ACCESSORIES

ORDER NO.
POS. DESIGNATION
1 2321 879 StandardSpray spray attachment (yellow) (with 1000 ml container)
Processes all standard paints.
2 2321 877 FineSpray spray attachment (brown) (with 1000 ml container)
Ideal for low-viscosity paints and glazes.
3 2321 880 WallSpray spray attachment (white) (with 1400 ml container)
Designed for processing dispersions.
4 Container with cover (1400 ml)
2324 749
Can Adapter
5
2350 692
With the Can Adapter, paint cans can be attached directly to a Click&Paint spray attachment.
Suitable for: commercially available 750 ml paint tins (maximum dimensions Ø=102 mm, h=119 mm)
and 1000 ml paint tins (maximum dimensions Ø=112 mm, h=132 mm).
The FC 3500 cannot be used with the heatable TempSpray spray attachment.
24
CAUSE
•
Material volume too large
•
Nozzle contaminated
•
Viscosity of coating material too high
•
Too little pressure build-up in
container
•
Air filter heavily soiled
•
Amount of air too low
•
Coating material in container running
out
•
Nozzle seal is missing or worn
•
Air filter heavily soiled
•
Feed tube loose
•
Feed tube / feed tube filter clogged
•
Too much coating material applied
•
Distance too small
•
Incorrect spray attachment
•
Distance to the object too large
•
Too much coating material applied
•
Amount of air too high
•
Coating substance over-diluted
•
Incorrect spray attachment
•
Incorrect spraying technique
•
Diaphragm soiled
•
Diaphragm defective
FinishControl 3500
REMEDY
•
Reduce volume
•
Clean
•
Dilute further
•
Tighten container
•
Change (see section 13.1)
•
Increase volume
•
Refill
•
Insert an intact nozzle seal
•
Change (see section 13.1)
•
Insert
•
Clean or use another filter
•
Reduce volume
•
Increase distance
•
Use another spray attachment
•
Reduce distance
•
Reduce volume
•
Reduce volume
•
Reduce degree of dilution
•
Use another spray attachment
•
For information about the correct spraying
technique, please see chapter 9
•
Clean the diaphragm (see section 13.2)
•
Replace the diaphragm (see section 13.2)