Intended Use - Hilti NPU 100 IP-A22 Manual De Instrucciones Original

2.3 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Product overview
3.2

Intended use

The product described is a cordless electro-hydraulic punching tool. It is designed for punching round,
square and rectangular holes in steel, aluminum, plastic or fiberglass parts.
Use only the punching dies available through the manufacturer.
Before starting work, check that the sheets to be punched and everything in the work zone (e.g. distribution
box/switch cabinet) are not electrically live.
▶ Use only Hilti Li­ion batteries of the B 18 and B 22 series with this product.
3.3 Possible misuse
• Do not use this hand-held power tool clamped in a fixed position or as a stationary device.
• Do not punch electrically live parts.
3.4 Lithium­ion battery status display
The state of charge of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The state of charge of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the "Troubleshooting" section.
4 English
Printed: 13.06.2018 | Doc-Nr: PUB / 5436086 / 000 / 00
1
Punching head
@
Manual piston return switch
;
Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Slot on both sides to fasten the Hilti retaining
)
leash
White LED to illuminate the working area
+
Control switch
§
Meaning
• State of charge: 75 % to 100 %
• State of charge: 50 % to 75 %
• State of charge: 25 % to 50 %
• State of charge: 10 % to 25 %
• State of charge: < 10 %
2200480
*2200480*