Intended Use - Hilti TE 700-AVR Manual De Instrucciones

3.2 Intended use

The product described is an electrically powered breaker for medium-duty
chiseling work. It is designed for removing and breaking up concrete,
masonry and stone.
▶ Operation is permissible only when connected to a power source
providing a voltage and frequency in compliance with the information
given on the type identification plate.
3.3 Active Vibration Reduction (AVR)
The breaker is equipped with an Active Vibration Reduction (AVR) system,
which reduces vibration significantly.
3.4 Service indicator
The breaker is equipped with a service indicator LED.
Status
The service indicator lights red.
The service indicator blinks red.
Bring the product to Hilti Service in good time. This will help to ensure
that it's always ready for use.
3.5 Power level indicator
The breaker is equipped with a power level indicator LED.
Chiseling power can be reduced to approx. 70% by pressing the power
level selector switch. The power level LED then lights up, indicating reduced
power.
3.6 Restart interlock
The tool doesn't restart automatically when the power returns after an
interruption in the supply. The on/off switch must first be released and then
pressed again to restart.
3.7 Items supplied
Breaker, side handle, operating instructions.
You can find other system products approved for your product at your
local Hilti Center or online at: www.hilti.com
*428076*
428076
Meaning
End of service interval – servicing is
due.
A fault has occurred in the tool.
The overheating prevention cut-out
has been activated.
The voltage provided by the electric
supply is too high.
English 7