Maintenance - Ryobi RY42144 Manual Del Operador

VACUUM OPERATION
See Figure 10.
WARNING:
Never run the unit without the vacuum tubes and vacuum
bag installed. Use of an improperly assembled unit could
result in serious personal injury.
 Install the vacuum tubes and bag. Refer to the Assembly
section earlier in this manual.
 Place the vacuum bag strap over your shoulder and hold
the handle knobs in your hands. (Proper operating posi-
tion is shown in fig. 10.)
 Start the blower/vac. Refer to Starting/Stopping the
Blower/Vac earlier in this manual.
 Move the unit from side to side along outer edge of the
debris. To avoid clogging, do not place the vacuum tube
directly into the debris pile.
WARNING:
Before inspecting, cleaning or servicing the machine,
unplug the power cord and wait for all moving parts to
stop. Failure to follow these instructions can result in
serious personal injury or property damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
OPERATION
 Hold the motor higher than the inlet end of the vacuum
 Always point vacuum tube downhill when working on a
 To avoid injury to the operator or unit, do not pick up
 If the vacuum tubes should clog, stop the motor, unplug

MAINTENANCE

Page 10 – English
tube.
hillside.
rocks, broken glass, bottles, any type of metal objects,
or other similar objects.
the power cord, and wait for all moving parts to stop
before cleaning out the obstruction. Remove the vacuum
tubes and clear the debris from the blower fan housing.
Remove the bag and clear the tube. A small rod or stick
may be required to clear the entire tube length. Ensure
that all debris has been cleared before reassembling the
vacuum tubes.
WARNING:
This appliance is provided with double insulation. When
servicing, use only identical replacement parts. Use of
any other parts could create a hazard or cause product
damage. See instruction for servicing of Double-Insulated
Appliances.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.