Brizo MultiChoice 60 Serie Instrucciones Para La Instalación página 4

60 Series Installation
2
Showerhead and Tub Spout Installation
2
FOR SHOWERHEAD INSTALLATION:
Connect top outlet (1) to shower arm (2) with
proper fittings. To prevent damage to finish on
shower arm, insert wall end of shower arm into
shower flange (3) before screwing arm into riser
connection. Thread showerhead (4) onto shower
arm. Apply plumber tape to pipe threads on both
ends. Do not overtighten showerhead.
FOR TUB SPOUT INSTALLATION:
Install 1/2" (13 mm) threaded pipe nipple (1) to extend past finished wall (2) per dimension (3).
Connection of deck mount spouts to in–wall valves is not recommended. Neither is the use of hand
showers connected to tub spouts in a tub/shower push button diverter combination, or hand showers
connected in lieu of a tub spout to a tub / shower valve. Piping between valve body and tub spout must
be a minimum of 1/2" (13 mm) copper pipe or 1/2" (13 mm) iron pipe in a straight drop no less than 8"
(203 mm) but no more than 18" (457 mm) long with only one iron pipe or copper 90 degree elbow to
the tub spout nipple. Apply plumber tape to threads on pipe nipple and screw on tub spout.
RP74644s
s Specify Finish
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
RP54874s
s Specify Finish
(3) = 9/16" ± 1/16" (14.3 mm ± 1.5 mm)
RP49094s
s Specify Finish
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
76130 Rev. A
1
3
4
1
3
2
1
3
2
1
3
2
4
3
2
FOR RSVP AND SOTRIA SHOWERHEAD
®
AND SHOWER ARM INSTALLATION:
1/2" threaded pipe nipple to extend beyond the
finished wall 3/8" to 1/2". Apply plumber tape to
thread on pipe nipple and screw brass adapter (1)
securely onto nipple. Apply plumber tape to outlet
end of shower arm and screw showerhead (2)
onto the shower arm (3), using provided wrench
(4) to tighten securely. Check position of set screw
on top of shower arm (3) making sure it is not
sticking through to the inside opening where it
could interfere with the assembly. Slide shower
arm and head assembly over the adapter and
tighten set screw against the adapter.
RP49126s
s Specify Finish
(3) = 5 3/8" ± 1/16" (136.5 mm ± 1.5 mm)
RP49345s
s Specify Finish
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
RP64084s Tub Spout & Flange/
Pull Down Diverter
RP49761s Spout Flange
s Specify Finish
(3) = 3/8" ± 1/16" (9.5 mm ± 1.5 mm)
1
4
Install a
1
3
2
1
3
2
1
3
2