S Pare Parts; R Epair; Arranty; S Torage - SUHNER UPG 5-R Documentación Técnica

4.1.1 c
hAnging the cArBon Brushes
The machine is equipped with two carbon brush-
es. The carbon brushes must be changed as fol-
lows:
Loosen the screws and remove the cover.
Raise the spring, and remove the carbon brushes. Clean
the carbon brush holders. Insert new carbon brushes.Re-
place the cover and tighten the screw.
4.2 s
pAre pArts
See page 2-3.
4.3 r
epAir
If despite strict observance of the manufacturing and test-
ing method the tool should happen to fail, it must be re-
paired by an authorized SUHNER agency.
Any replacement needed for the connecting line must be
installed by the manufacturer or its agent if safety risks are
to be eliminated.
4.4 w

ArrAnty

In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the machine is re-
turned in the undisassembled condition.
4.5 s
torAge
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.6 d / e
isposAl nVironmentAl compAtiBility
The machine consists of materials which can be recycled
in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collec-
tion
According to national regulations this machine must be
recycled in an environmentally-friendly manner.
23