Standard Accessories; Maintenance And Inspection - Hitachi DV 13SS Instrucciones De Manejo

English

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
Model Drill chuck spec.
DV13SS Keyed
Keyed
DV13VSS
Keyless
DV16SS Keyed
Keyed
DV16VSS
Keyless
Standard accessories are subject to change without notice.
SPECIFICATIONS
Model
Voltage (by areas)*
Power input*
Reversible
No load speed
Drill chuck capacity
Steel
Capacity Concrete
Wood
Full-load impact rate
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
MOUNTING AND OPERATION
Action
Fixing and removing side handle
Using depth stopper
Mounting and dismounting of
the bit
Dismounting the bit of keyless
chuck (When the keyless chuck
cannot be loosened)
Selecting rotation direction
Selecting the operating mode
Switch operation
Locking-on the switch
Releasing the switch
Selecting accessories
Standard accessories
Chuck wrench ..........1
Chuck wrench ..........1
Case ........................1
Depth gauge ............1
Side handle ..............1
Chuck wrench ..........1
Depth gauge ............1
Side handle ..............1
Chuck wrench ..........1
Depth gauge ............1
Side handle ..............1
Case ........................1
Depth gauge ............1
Side handle ..............1
DV13SS DV13VSS
(110 V, 120 V, 127 V, 220 V, 230 V, 240 V)
550 W
None
2900 min 0 – 2900 min
-1
13 mm
20 mm
1.4 kg
Figure Page
1 103
2 103
3 103
4 104
5 104
6 104
7 104
8 104
9 104
― 105
APPLICATIONS
○ By combined actions of ROTATION and IMPACT:
Boring holes in hard materials (concrete, marble, granite,
tiles, etc.)
○ By ROTATIONAL action:
Boring holes in metal, wood and plastic.
DV16SS
Yes None
2900 min
-1
13 mm
13 mm
29000 min
-1
Selecting the appropriate drill bit
○ When boring concrete or stone
Use the drill bits specifi ed in the Optional Accessories.
○ When boring metal or plastic
Use an ordinary metalworking drill bit.
○ When boring wood
Use ordinary woodworking drill bit.
However, when drilling 6.5 mm or smaller holes, use a
metalworking drill bit.

MAINTENANCE AND INSPECTION

1. Inspecting the drill bits
Since use of an abraded drill bits will cause motor
malfunctioning and degraded effi ciency, replace the drill
bits with a new one or resharpening without delay when
abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4
DV16VSS
600 W
Yes
0 – 2900 min
-1
16 mm
25 mm
1.5 kg
-1