Homelite UT10544 Manual Del Operador página 35

 Remove the screws and cylinder cover as
described previously.
 Clean the cylinder fins.
 Lift the chain brake over the post.
 Lay the chain saw on its side with the bar and
chain on the ground.
 Remove the chain oil and fuel caps.
 Remove the three screws that hold the starter
housing in place.
 Lift off the starter cover and set aside.
 Replace chain oil and fuel caps to prevent con-
tamination during cleaning.
 Clean the flywheel fins.
 Remove the chain oil and fuel caps.
 Replace the starter housing. Reinstall screws
and secure.
 Replace the chain oil and fuel caps.
 Replace the cylinder cover. Reinstall screws and
secure.
 Replace the chain brake on the post.
NOTE: Check to ensure that the air filter is in the
proper position before reinstalling the cylinder
cover.
NOTE: If you notice a power loss with the gas-
powered tool, the exhaust port and muffler may
be blocked with carbon deposits. These deposits
may need to be removed to restore performance.
We highly recommend that only qualified service
technicians perform this service.
MAINTENANCE
CHAIN BRAKE
Page 35 — English
FUEL CAP
CHAIN OIL
CAP
POST
STARTER
COVER
Fig. 66
CLEAN
CYLINDER FINS
CLEAN
FLYWHEEL FINS
Fig. 67
Fig. 68