Assembly; Start Up - Truper SICI-7-1/4A3 Manual De Instrucciones

Cutting disc assembly
WARNING
The cutting discs' size specified for this
tool are 7-1/4" Never use a cutting disc of different type or
size. Otherwise it can cause severe personal injury or
damage the tool permanently and making the warranty
void.
Never use damaged or incorrect washers or bolts for
discs. To get excellent and safe operation the washers and
bolts included are specially designed for this model of
tool.
Use cutting discs with an arbor hole of the right size and
shape. Otherwise the disc may start rotating eccentrically
causing loss of control.
1. Unplug the tool and adjust the cutting depth to the
lowest setting. (See page 9).
2. Open the retractile guard all the way (A) and keep it in
that position.
3. . Insert the inner flange (B) in the axis.
4. Fix the cutting disc (C). Double-check the printed arrow
in the disc matches the direction of the arrow embossed
in the tool's guard.
5. . Insert the outer flange (D) in the axis.
6. Fix the bolt (E) into the axis and tighten with the hex
key (F) and press the axis security button (G).
7. To remove discs reverse the steps.
The circular saw is a multi-use tool to cut hard or soft wood, plywood, Resopal covered materials, etc.
CAUTION
This tool is not designed to cut metal material, masonry, cement or bricks.
Turning On
• Connect the plug to the outlet.
• To unblock the switch (H) keep the switch lock (G) pressed down.
The switch lock prevents from accidental start up.
• Press the switch (H) to start the disc rotation.
• To stop the disc release the switch (H).
8
ENGLISH

Assembly

When the cutting discs wear out, replace them
immediately
E
D
B
Only clean, sharp and properly fixed can
guarantee a good cut. Keep handy extra cutting
discs to have sharp discs always available

Start Up

G
F
C
A
G
H