Unpacking And Assembly - Truper SINCO-10X2 Manual De Instrucciones

22
18
17
23
24
34

Unpacking and assembly

Due to tight quality controls there is a small probability that
the tool has defects or missing parts. If there is any
problem, before using the tool and to prevent severe
injury, please go to a
Service Center.
• Remove all loose parts from the packaging before
unpacking the tool.
• Remove the packing material around the tool.
• Carefully lift the saw grasping only by the carrying handle
(6). Sit the unit onto a totally leveled surface.
• Always carry the tool with the cutter head set down and
blocked with the lock knob (3). Lift the saw only using the
carrying handle.
Prevent back injury. Seek help to lift the saw.
6
Parts
19
Authorized
3
2
20
31
29
16
Mounting onto a work bench
• Find four orifices in each one of the four supports to fix the
base onto a worktable.
• Fix the base onto a perfectly leveled worktable. Use
screws (not included).
• Or, fix the base onto 1/2" or larger piece of plywood to
be able to fasten the board to the table or to carry it to
different work places.
WARNING
• Assembling the tool onto a warped,
tilted or irregular surface will cause uneven cuts.
Cutter head release
• Once the tool is assembled, use the lock knob (3) to free
the cutter head and use the saw.
• Press down the cutter head while pulling out the lock
knob.
• Then lift the cutter head slowly, until it stops again with
the lock that is outwards.
• Release the lock.
• To secure the cutter head again, lower it to the top of the
cutter head, without releasing the cutter head, push the
lock up to the bottom and release both.
5
4
11
14
12
3
27
17
24
ENGLISH
4
35
7