Descargar Imprimir esta página

Craftsman CMXEVCVVJH1211 Manual De Instrucciones página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
21. Disconnect the hose
Undo the latches
head
12
from the collection tank. Fig 13.
Place power head on soft, clean surface
upside down. Clear all dirt or debris from
the collection tank and hose. Place power
head back onto the collection tank and
secure latches.
Fig. 13
Wet Pick Up Operation
IMPORTANT! When vacuuming large quantities
of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip
of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops
the suction action when the collection tank
reaches its maximum capacity. You will notice
an increase in motor speed.
WARNING:
HAPPENS, TURN OFF THE MACHINE,
DISCONNECT FROM POWER SUPPLY,
AND DRAIN THE LIQUID INTO A SUITABLE
RECEPTACLE OR DRAIN. TO CONTINUE
VACUUMING, REFIT THE COLLECTION
TANK WITH THE DRAIN CAP. AFTER WET
VACUUMING, TURN THE MACHINE OFF
AND REMOVE PLUG FROM POWER SUPPLY.
EMPTY THE COLLECTION TANK, CLEAN AND
DRY THE INSIDE AND OUTSIDE BEFORE
STORAGE.
WARNING:
LIQUID, THE TANK MAY BECOMING HEAVY.
SEEK ASSISTANCE IF TANK IS TOO HEAVY
TO MOVE OR LIFT TO AVOID INJURY.
8
15
from the vacuum.
5
and remove the power
WHEN THIS
WHEN FILLED WITH
NOTICE: The foam wet filter must be removed
after wet vacuuming and the cartridge filter
must be installed before dry vacuuming again.
FOAM WET FILTER INSTALLATION
AND CLEANING:
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
22. Remove the power head and place in an
upside down position. Follow instructions
to remove the cartridge filter on page 7.
23. Carefully slide the foam wet filter
over the filter cage making sure the cage is
completely covered. Fig. 14.
Fig. 14
24. To remove the foam wet filter, place the
removed power head in an upside down
position, and carefully remove the foam
22
wet filter
. Fig. 15.
Fig. 15
25. Use a mild soap and water solution to
wash the foam wet filter
clean water. Fig. 16.
VERIFY THAT THE
22
down
22
and rinse with

Publicidad

loading