Celestron TRAILSEEKER Manual De Instrucciones página 7

BALANCE PLATE (FOR THE 100 MM MODEL)
The TrailSeeker 100 mm spotting scope comes with a balance
plate to properly balance the spotting scope when attached to a
tripod (Fig. 11). To use the balance plate, mount it to the tripod's
¼"-20 mounting screw using the ¼"-20 threaded hole located on
the bottom of the plate. Attach the spotting scope to the balance
plate using the ¼"-20 mounting screw located on the top of the
plate and thread it into the spotting scope as far as it will go.
Slide the spotting scope along the slotted portion of the plate
until the spotting scope is balanced on the tripod. Tighten the
locking ring to hold the spotting scope in the desired position.
DIGISCOPING
The TrailSeeker spotting scopes can be used for digiscoping
with SLR cameras and point-and-shoot digital cameras. Please
note that not all cameras are compatible for digiscoping and in
some cameras vignetting (a circular image surrounded by black)
will occur. Point-and-shoot cameras with an optical zoom of 3x
or 4x tend to be the most compatible with the least amount of
vignetting. When using a zoom eyepiece, photographs will be
the sharpest and brightest when the eyepiece is set at the lowest
magnification.
¼"-20
Mounting Screw
¼"-20
Threaded Hole
(not shown)
Locking Ring
Mounting Screw
Fig. 11
ENGLISH I
7