Unpacking; Requirements For The Installation Location; Before The First Use; Child Lock - Graef WK 900 Manual De Instrucciones

use any solvents.
Do not scratch off stubborn soiling with hard objects.
•
Do not rinse the unit off in water or immerse it into water.
•

UNPACKING

To unpack the unit, proceed as below:
Take the unit out of the carton.
•
Remove all pieces of the packing.
•
Remove any possibly extant labels on the unit (do not remove the rating plate).
•

REQUIREMENTS FOR THE INSTALLATION LOCATION

For safe and flawless operation of the unit, the place of location must meet these
prerequisites:
The unit must be set up on a firm, flat, level and non-slip base that has
•
sufficient load bearing capacity.
Make sure the unit cannot fall over.
•
Select the location so that children cannot reach the hot surfaces of the unit
•
and cannot touch the cable.

BEFORE THE FIRST USE

Read these operating instructions thoroughly and keep them handy for referral
later on.
This unit brings water to boil in a few minutes.
To clean the unit, first fill the unit with clear, cold water and then boil it.
Subsequently pour away the water.

CHILD LOCK

Via a hidden switch on the bottom of the electric kettle you can activate the child
lock. From now on, the appliance only heats water up to the desired temperature
if you confirm this by pushing the BOIL-button.
To activate the child lock, slide the switch (by using a pen) to the closed lock
symbol. To deactivate the child lock, slide the switch (by using a pen) to the
open lock symbol.
Note: After deactivating the child lock please wait for 30 minutes to unload the
energy memory. To unload the energy memory put the kettle beside the base
plate.

BOILING WATER

Take hold of the base station and unwind the cable as far as it goes.
•
Open the lid and fill the unit with water.
•
Important: Make sure you do not exceed the internal maximum filling level
mark.
The child lock is deactivated now.
DE
EN
FR
NL
IT
ES
NO
S
DK
PYC
15