Information Concerning Disposal; Disposal Of Packaging; Disposal Of Your Old Appliance; Installing The Appliance - Thermador T24UC920DS Manual De Uso

Information concerning
disposal

Disposal of packaging

The packaging protects your appliance from
damage during transit. All utilized materials are
environmentally safe and recyclable. Please
help us by disposing of the packaging in an
environmentally friendly manner. Please ask
your dealer or your local authority about current
means of disposal.

Disposal of your old appliance

Old appliances are not worthless rubbish!
Valuable raw materials can be reclaimed by
recycling old appliances.
WARNING:
1. Pull out the power plug.
2. Cut off the power cord and discard with
the power plug.
3. Remove the door from the appliance.
4. Do not allow children to play with the
appliance once it has spent its useful
life. Danger of suffocation!
Refrigerators contain refrigerant and gases in
the insulation. Refrigerant and gases must be
recycled by professionals. Ensure that tubing of
the refrigerant circuit is not damaged prior to
proper disposal.

Installing the appliance

For detailed installation instructions, please
refer to the Installation Guide provided with
the appliance.
Have a qualified technician install and
connect the appliance according to the
enclosed installation instructions.
NOTE: For detailed installation instructions,
relevant measurements and information,
please, see the Installation Guide provided
with this appliance.
WARNING:
Do not install this appliance:
- Outdoors
- In an environment with dripping water
- In rooms where there is a risk of frost

Transporting

The appliance is heavy and must be handled with caution
during transportation and installation. Because of the weight
and dimensions of the appliance, at least two persons are
necessary to move the appliance into position securely and
avoid injuries to people or damage to the appliance.

Installation location

A dry, well ventilated room is suitable as an installation
location. The installation location should not be exposed to
direct sunlight and not placed near a heat source, e.g. a
cooker, radiator, etc.
If installation next to a heat source is unavoidable, use a
suitable insulating plate or observe the following minimum
distance from the heat source:
▪ To electric or gas cookers 1¼" (3 cm).
▪ To an oil or coal-fired cooker 11
The floor of the installation location must not give way; if
required, reinforce floor. The appliance must be upright and
level to function correctly.

Ventilation

The refrigeration unit is ventilated only at the Toe-Kick
in the base. Never cover that area or place anything in
front of it. Otherwise the refrigeration cooling performance
will be affected and the unit must work harder increasing
power consumption.
Additionally, make certain all 4 leveling legs are extended
(unit height approximately 34 ¾"), so that there is sufficient
airflow underneath the appliance.
Adjust all 4 legs to extend the appliance
height by approximately 1/2 inch.

Water connection

Connect the appliance to a drinking water line.
The water may be connected only by a competent plumber
according to the local regulations of the appropriate water
supply company.
A cold water connection is necessary for operating the
automatic ice maker.
The water supply pressure must be between 30 and 120
p.s.i. (2.06 and 8.27 bar). In case a reverse osmosis
system is used the pressure of the water supply from this
system going to the
13
/
" (30cm).
16
Page | 5