FYTTER Runner RU-4RX Manual Del Usuario página 44

PROBLEM
Treadmill will 1. Not plugged in.
2. Safety key not attached
not start
correctly.
3. Treadmill circuit breaker
tripped.
4. On/Off switch not turned on.
5. Auto shut down timed out.
Treadmill belt 1. Walking belt too loose.
2. Deck needs lubrication.
slipping
Treadmill noisy 1. Loose hardware.
2. Motor straining.
3. Clicking sound-roller knocking.
Inaccurate pulse 1. Too much hand movement.
2. Palms too wet.
rate
3. Gripping handgrips too tight.
4. Wearing rings.
POSSIBLE CAUSES CORRECTION
1. Tighten into suitable outlet.
2. Insert safety pull pin.
3. Reset circuit breaker.
4. Turn on On/Off switch.
5. Unplug and re-plug electrical cord.
1. Tighten walking belt.
2. Lubrication belt and deck.
1. Tighten visible screws, nuts and bolts.
2. Check the belt tension-3 finger test.
3. Adjust rear rollers-check the tension.
1. Stand on the side rails to obtain accurate
pulse reading.
2. Dry palms.
3. Grip using moderate pressure.
4. Remove all rings.
FYTTER |WWW.FYTTER.COM PAG- 43