Kenwood KDC-BT310U Manual De Instrucciones página 17

Symptom Remedy
"ADD ERR" New station creation is unsuccessful.
"SEARCH ERR"
"CHK DEVICE" Check the Pandora application on your device.
"NO SKIPS" The skip limit has been reached.
"NO STATIONS" No stations are found.
"STATION LIM" The number of registered stations has reached its
limit. Retry after deleting unnecessary stations from
your device.
"UPGRADE APP" Make sure you have installed the latest version of the
Pandora application on your device.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. (➜ 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to
both the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. (➜ 9)
"DEVICE FULL" appears. The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. (➜ 11,
SETTINGS ➜ PAIRING ➜ DVC DELETE)
Echo or noise occurs. Check the [ECHO LEVEL] setting. (➜ 11)
Phone sound quality is poor. • Reduce the distance between the unit and the
Bluetooth device.
• Move the car to a place where you can get a better
signal reception.
Symptom Remedy
Voice calling method is not • Use voice calling method in a more quiet environment.
successful. • Reduce the distance from the microphone when you
speak the name.
• Make sure the same voice as the registered voice tag is
used.
"NOT SUPPORT" appears. The connected phone does not support Voice
Recognition feature.
"ERROR" appears. Try the operation again. If "ERROR" appears again,
check if the device supports the function you have
tried.
Sound is being interrupted • Reduce the distance between the unit and the
or skipped during playback Bluetooth audio player.
of a Bluetooth audio player. • Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to
the unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be supports Audio/Video Remote Control Profile (AVRCP).
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"HF ERROR" appears. Reset the unit and try the operation again. If this does
not solve the problem, consult your nearest service
center.
TROUBLESHOOTING
ENGLISH | 17