Cd / Usb / Ipod - Kenwood KDC-BT310U Manual De Instrucciones

CD / USB / iPod

Start playback
The source changes automatically and
playback starts.
CD
0: Eject disc
Label side
USB
USB input terminal
CA-U1EX (max.: 500 mA)
(optional accessory)
iPod/iPhone
USB input terminal
KCA-iP102 (optional accessory) *
1
Press and hold 5 iPod to select the
control mode while in iPod source.
MODE ON: From the iPod * 2
.
MODE OFF: From the unit.
6
To Do this
Press 6 38 (or ENT 38 on RC-406).
Pause or resume
playback
Press 4 / ¢ (or 4 / ¢ (+) on RC-406).
Select a track/file
Select a folder * 3
Press 1 – / 2 + (or
Press and hold 4 / ¢ (or 4 / ¢ (+) on RC-406).
Reverse/Fast-forward
Repeat play * 4
Press 4
• Audio CD: TRAC REPEAT, REPEAT OFF
• AAC/MP3/WMA file: FILE REPEAT, FOLD REPEAT, REPEAT OFF
• iPod or KENWOOD Music Editor Light (KME Light)/ KENWOOD Music Control
(KMC) file: FILE REPEAT, REPEAT OFF
Random play * 4
Press 3
• Audio CD: DISC RANDOM, RANDOM OFF
• AAC/MP3/WMA file or iPod or KME Light/ KMC file: FOLD RANDOM,
RANDOM OFF
Press and hold 3
*
1 To connect devices featuring Lightning connector, both KCA-iP102 (optional accessory) and Apple
Lightning to 30-pin Adapter (accessory of the iPod/iPhone) are required.
Do not leave the Apple Lightning to 30-pin Adapter inside the car to prevent damages caused by the
hot temperature.
* 2
You can still play/pause, use file selection, fast-forward or reverse files from the unit.
* 3
Only for AAC/MP3/WMA files. This does not work for iPod.
*
4 For iPod: Applicable only when [MODE OFF] is selected.
* 5
For CD: Only for AAC/MP3/WMA files.
Note:
Pairing request (via Bluetooth) is
automatically activated if an iPhone/
iPod touch is connected through the
USB input terminal. (➜ 9)
AM– / #FM+ on RC-406).
*
repeatedly.
repeatedly.
to select "ALL RANDOM". *
5