Audio Settings - Kenwood KDC-BT310U Manual De Instrucciones

AUDIO SETTINGS

While listening to any source...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [AUDIO CTRL], then press the knob.
3
Turn the volume knob to make a selection (see the following table),
then press the knob.
3
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
(or using RC-406)
1 Press AUD to enter [AUDIO CTRL].
Press 5/∞ to make a selection, then press ENT 38.
2
• To return to the previous hierarchy, press
SUB-W LEVEL –15 to +15 (0)
BASS LEVEL –8 to +8 (0)
MID LEVEL –8 to +8 (0)
TRE LEVEL –8 to +8 (0)
PRESET EQ NATURAL/ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL:
Selects a preset equalization suitable to the music genre. (Select [USER]
to use the customized bass, middle, and treble settings.)
BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred
bass boost level. ; OFF: Cancels.
LOUDNESS LOUD LV1/ LOUD LV2: Selects your preferred low and high frequency
boost to produce a well-balanced sound at a low volume level. ;
OFF: Cancels.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
SUB-W SET ON: Turns on the subwoofer output. ; OFF: Cancels.
14
.
Adjusts the subwoofer output level.
Adjusts the level to memorize for each source. (Before
making an adjustment, select the source you want
to adjust.)
DETAIL SET
LPF SUB-W
SUB-W PHASE
SUPREME SET
VOL OFFSET
Default: XX
(Default: 0)
• [SUB-W LEVEL]/ [SUB-W SET]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if
[SWITCH PRE] is set to [SUB-W]. (➜ 4)
• [SUB-W LEVEL]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if [SUB-W SET]
is set to [ON].
THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/
160HZ: Audio signals of frequencies lower than 85 Hz/ 120 Hz/ 160 Hz
are sent to the subwoofer.
REV (180°)/ NORM (0°): Selects the phase of the subwoofer output to
be in line with the speaker output for optimum performance. (Selectable
only if a setting other than [THROUGH] is selected for [LPF SUB-W].)
ON: Creates realistic sound by interpolating the high-frequency
components that are lost in AAC/MP3/WMA audio compression. ;
OFF: Cancels. (Selectable only when playing back an AAC/MP3/WMA
disc or a USB device, except iPhone/iPod.)
–8 to +8 (for AUX) ; –8 to 0 (for other sources): Presets the volume
adjustment level of each source. (Before adjustment, select the source
you want to adjust.)