Cutting Equipment - Husqvarna 536LiRX Manual De Instrucciones

WARNING! This machine is renowned for
!
its low vibration load. Overexposure to
vibration can lead to circulatory damage
or nerve damage in people who have
impaired circulation. Contact your doctor
if you experience symptoms of
overexposure to vibration. These
symptoms include numbness, loss of
feeling, tingling, pricking, pain, loss of
strength, changes in skin colour or
condition. These symptoms normally
appear in the fingers, hands or wrists.
Locking nut
Li-ion Li-ion
A locking nut is used to secure some types of cutting
attachment.
When fitting, tighten the nut in the opposite direction to the
direction of rotation of the cutting attachment. To remove
it, undo the nut in the same direction as the cutting
attachment rotates. (CAUTION! The nut has a left-hand
thread.) Lock the blade shaft with the L key.
When loosening and tightening the saw blade nut, there
is a risk of injury from the teeth of the saw blade. You
should therefore always ensure that your hand is shielded
by the blade guard when doing this. Always use a socket
spanner with a shaft that is long enough to allow this. The
arrow in the diagram shows the area where you should
operate the socket spanner when loosening or tightening
the nut.
The nylon lining inside the locking nut must not be so worn
that you can turn it by hand. The lining should offer a
resistance of at least 1.5 Nm. The nut should be replaced
after it has been put on approx. 10 times.
12 – English
GENERAL SAFETY PRECAUTIONS

Cutting equipment

Li-ion Li-ion
This section describes how to choose and maintain your
cutting equipment in order to:
• Reduce the risk of blade thrust.
• Obtain maximum cutting performance.
• Extend the life of cutting equipment.
IMPORTANT!
Only use cutting attachments with the guards we
recommend! See the chapter on Technical data.
Refer to the instructions for the cutting attachment to
check the correct way to load the line and the correct
line diameter.
Keep the teeth of the blade correctly sharpened! Follow
our recommendations. Also refer to the instructions on
the blade packaging.
The blade should be completely stationary once the
throttle has returned to its original position.
WARNING! Always remove the battery
!
before you work on any part of the
cutting equipment. It continues to rotate
even after the power trigger has been
released. Check that the cutting
equipment has stopped completely and
remove the battery before you start any
work on it.
Using an incorrect cutting attachment or
an incorrectly sharpened blade
increases the risk of blade thrust.
Always wear protective gloves.
Grass blades and grass knifes are intended for cutting
coarse grass.
A trimmer head is intended for trimming grass.