Husqvarna 536LiRX Manual De Instrucciones página 22

WARNING! Neither the operator of the
!
machine nor anyone else may attempt to
remove the cut material while the motor
is running or the cutting attachment is
rotating, as this can result in serious
injury.
Turn off the machine and remove the
battery before removing materials that
are wound around the trimmer head as
otherwise there is risk of injury. The
bevel gear can get hot during use and
may remain so for a while afterwards. You
could get burnt if you touch it.
WARNING! Watch out for thrown objects.
!
Always wear approved eye protection.
Never lean over the cutting attachment
guard. Stones, rubbish, etc. can be
thrown up into the eyes causing
blindness or serious injury.
Keep unauthorised persons at a
distance. Children, animals, onlookers
and helpers should be kept outside the
safety zone of 15 m. (50 ft.) Stop the
machine immediately if anyone
approaches. Never swing the machine
around without first checking behind you
to make sure no-one is within the safety
zone.
Safety instructions after completing work
• Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the battery.
SavE mode
The machine is equipped with a battery saving function
(SavE). Activate the function by pressing the SavE button.
A green LED will light to indicate that the function is on.
In most cases SavE mode is the most optimum when
trimming and gives longest runtime. Release the power
trigger after each working operation to save battery
power.
22 – English
WORKING TECHNIQUES
Rotation direction
It is possible to change the rotation direction of the
trimmer head in any position, at full speed or at stop
postion.
Trimmer head
When the rotation button is pressed, the green diode will
lit and the trimmer head rotates in counterclockwise. The
trimmer head always rotates clockwise by default (green
LED is off).
It is easier to tap out the trimmer line to make it longer
when the trimmer head rotates clockwise.
Grass blade/grass cutter
When using the grass blade or grass knife, working
rotation is anticlockwise only.
A clockwise direction of rotation is used to loosen any cut
material that has fastened on the trimmer head or blade.
IMPORTANT! If the direction of rotation is changed to
clockwise with blade, the blade speed will be reduced
for a certain period and then again rotate anticlockwise.
Automatic switch off functionality
The machine is equipped with a shutdown feature that
deactivates the machine if not used. The green LED will
be extinguished and the machine turned off after 45
seconds.
Grass trimming with a trimmer head
WARNING! Sometimes branches or
!
grass get caught between the guard and
cutting attachment. Always remove the
battery before cleaning.