Wipe Protection; Automatic Time Limitation; Basic Settings - Bosch NITP068SUC Manual Del Usuario

Wipe protection

Cleaning the control panel while the cooktop is on may
change the settings. In order to avoid this the cooktop
has a wipe protection function.
To activate: Touch the Panel Lock key. An acoustic
signal sounds. The control panel is locked for
35 seconds. You can now wipe over the surface of the
control panel without altering any settings.
To deactivate: The control panel will be unlocked once
35 seconds have elapsed. To release the function early,
touch the Panel Lock key.
Notes
An audible signal sounds 30 seconds after activation.
▯
This indicates that the function is about to finish.
The wipe protection function does not lock the main
▯
switch. The cooktop can be switched off at any time.

Basic settings

The appliance has various basic settings. You can adjust
these settings to the way you usually cook.
Display Function
Automatic child lock/panel lock
Manual*.
‹
Automatic.
‚
Function deactivated.
™‚ ƒ
Signal tones
Confirmation and error signals are switched off.
‹
‚ Only the error signal is switched on.
Only the confirmation signal is switched on.
ƒ
All signal tones are switched on.*
™ƒ „
Display energy consumption
Switched off.*
™„ ‹
Switched on
‚
Automatically setting the cooking time
‹‹ Switched off.*
- Time until automatic switch-off.
™† ‹‚ ŠŠ
Audible signal duration for the timer function
10 seconds.*
‚
30 seconds.
ƒ
1 minute.
™‡ „
Power management function. Limiting the total power of the cooktop
‹ Switched off.*
1000 W minimum power.
‚
. 1500 W
‚
2000 W
ƒ
...
Maximum power of the cooktop.
™ˆ Š
* Factory settings

Automatic time limitation

If the element is used for prolonged periods of time
without changes in the settings being made, the
automatic time limitation function is triggered.
The element stops heating.
indicator / flash alternately in the display.
• œ
The indicator goes out when any symbol is pressed. The
element can now be reset.
When the automatic time limitation is activated depends
on the selected heat level (from 1 to 10 hours).
"‰ and the residual heat
17