Dpt70 Bodypack Transmitter; C111 Lp Ear Hook Microphone; Putting On The Microphone; Windshield - Harman AKG DMS70 Quattro Modo De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Microphone technique

DPT70 bodypack transmitter

18

C111 LP ear hook microphone

Putting on the microphone

1)
Put the microphone on.
2)
Bend the gooseneck so that the microphone sits to one side in front of the corner of your
mouth.
 If you hear excessive pop noise ("p" and "t" sounds are overemphasised unnaturally),
move the microphone capsule further away from your mouth (back or down).
 If the microphone sounds "thin" or flat, move the microphone capsule closer to your
mouth.
NOTE
 Find the optimum position during the soundcheck.

Windshield

If (for instance, on an open-air stage) excessive wind or pop noise becomes audible, attach
the supplied foam windshield to the microphone.
1)
Slide the windshield onto the microphone capsule.
2)
Pull the windshield over the outer end of the microphone capsule.

Moisture shield

A special moisture shield on the microphone capsule makes it harder for moisture and make-
up to penetrate into the microphone.
This prevents the microphone apertures from being clogged by perspiration or make-up,
which would make the sound dull and reduce the sensitivity of the microphone. Therefore, you
should never remove the moisture shield from the microphone.
DMS70 Quattro

Publicidad

Tabla de contenido
loading

Tabla de contenido