Descargar Imprimir esta página

Philips Lumea SC198 Serie Manual Del Usuario página 19

Ocultar thumbs Ver también para Lumea SC198 Serie:

Publicidad

Note: If the 'ready to flash' light lights up
orange continuously the device is not
completely in contact with your skin.
TIP: If you use Lumea on your bikini area and
want to leave some hair in place, make sure
that the skin tone sensor is not placed on the
remaining hair during the treatment, as this
can cause the device to block
6 Press the flash button to release a flash. The
devices makes a soft popping sound. You
should feel a warm sensation because of the
flash.
Note: The light produced by the device is
harmless to your eyes. It is not necessary to
wear goggles during use. Use the device in a
well-lit room so that the light is less glaring to
your eyes.
7 Place the device on the next area to be treated.
After each flash, it takes up to 3.5 seconds until
the device is ready to flash again. You can
release a flash when the 'ready to flash' light
lights up again.
8 To make sure that you have treated all areas,
release the flashes close to each other.
Effective light only comes out of the light exit
window, therefore there should be some
overlap. However, make sure you flash the
same area only once. Flashing the same area
twice doesn't improve the effectiveness of the
treatment, but increases the risk of skin
reactions.
9 When you have finished the treatment, press
and hold the on/off button for 2 seconds to
switch off the device.
17
English

Publicidad

loading

Este manual también es adecuado para:

Lumea sc1985Lumea sc1984Lumea sc1983