Connect Water Line To Fill Valve - Whirlpool W10806906H Instrucciones De Instalación

11.
Measure cabinet opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed.
Be sure to measure the lowest point on the underside
of the countertop and the highest point on the floor.
Dishwasher Height Adjustment Chart
Cabinet opening Front legs
height height
33 / " (851 mm) / " (9.8 mm)
1 3
2 8
34" (864 mm) / " (14 mm)
9
16
34 / " (871 mm) / " (21 mm)
1 13
4 16
34 / " (876 mm) / " (27 mm)
1 11
2 16
Front legs – A
Adjust both front leveling legs to the same height. Put the rear
wheels in the correct position according to the "Dishwasher
Height Adjustment Chart."
NOTE: If the minimum cabinet opening height is less
than 34" (864 mm), the rear wheels can be removed for
additional clearance.
This will allow the dishwasher to fit into a 33
high cabinet opening, but the dishwasher will be more
difficult to move. Measurements are approximate.
12
Wheel Insulation
position blanket
Removed Cut
1 No Cut
2 No Cut
3 No Cut
/ " (851 mm)
1
2
12.
Adjust wheels and legs
Refer to the "Dishwasher Height Adjustment Chart" for wheel
position and for height of front legs needed for your cabinet
opening height.
13.
Remove plastic rail cover
(only on certain models)
Plastic
rail cover
Remove and discard the plastic rail cover on each side of
the dishwasher frame. To remove the plastic rail cover, push
upward and back to unsnap it from the dishwasher frame.

CONNECT WATER LINE TO FILL VALVE

– For Copper line, begin with Step 14
– For Flexible line, begin with Step 16
14.
Copper water line
If using copper tubing, measure overall length of copper
tubing required to reach the water supply, cut to length, and
attach with compression fittings.